How to operate the spray gun and pressure bottle?
When we delivery the machine, Yatai polishing company will send a wax bottle and spray gun. It will help the customer to operate the polishing machine. How can we use the bottle and spray gun?
When the spray system is working, you must be used carefully to avoid injury because the compressed air is connected to the inside of the barrel. When adding wax, first open the exhaust valve on the lid to discharge the pressure in the bucket. Make sure that there is no pressure in the bucket before opening the lid. Then loosen the six wing nuts on the lid and uncover the lid (Note! Whether the sealing glue in the lid is positive, otherwise it will leak). Lock the wing nut. The lock nut is evenly locked to the coping angle, and can not be locked on one side and then on the other side. After locking, slowly open the intake valve, observe the pressure gauge, adjust the pressure regulator to the proper pressure, and you can use it normally. The maximum working pressure when the wax barrel is working must not exceed 0.7Mpa.
The amount of spray can be adjusted on the screw cap behind the spray gun. The break time of the spray can be set in the touch screen. The nozzle is equipped with an adjustable nozzle in the front section to adjust the spray angle and orientation. After the nozzle is used for a period of time, the nozzle will become worn and become larger. When the nozzle effect cannot meet the production needs, the nozzle should be replaced.
During use, the spray gun may be clogged due to impurities in the wax. At this time, the spray gun can be unloaded and cleaned with compressed air or clean water. Hot water or other corrosive solutions above 60°C must not be cleaned.
(NOTE! The gun nozzle must never be pointed at a person during work.)
When you stop using the spray gun system after work every day, close the filter outlet valve on the wax drum.